Firefly开源社区

打印 上一主题 下一主题

(已解决)FirePrime开机卡着了,求助!!!

36

积分

0

威望

0

贡献

游客

积分
36

(已解决)FirePrime开机卡着了,求助!!!

发表于 2016-11-2 14:44:09      浏览:5515 | 回复:2        打印      只看该作者   [复制链接] 楼主
本帖最后由 chenchenc01234 于 2016-11-3 11:39 编辑

打印信息如下:
[    3.272374] [WLAN_RFKILL]: rockchip_wifi_power: 0
[    3.310512] Cam_Powerdowm
[    3.344795] min_w = 800,min_h = 600 ,max_real_w = 1600,max_real_h = 1200,max_w = 1600,max_h =1200
[    3.346165] ov2659_front_4(rk_cam_sensor:169): write reg(0x103, val:0x1) failed, try to write again!
[    3.347493] ov2659_front_4(rk_cam_sensor:169): write reg(0x103, val:0x1) failed, try to write again!
[    3.348823] ov2659_front_4(rk_cam_sensor:169): write reg(0x103, val:0x1) failed, try to write again!
[    3.348860] ov2659_front_4(rk_cam_sensor:387): write array failed!
[    3.348876] ov2659_front_4(rk_cam_sensor:671): soft reset failed
[    3.348876]
[    3.361426] ov2659_front_4(rk_cam_sensor:335): read reg(0x300a val:0x0) failed, try to read again!
[    3.361461] ov2659_front_4(rk_cam_sensor:699): read chip id failed
[    3.372248] systemd[1]: Failed to insert module 'autofs4'
[    3.379379] [WLAN_RFKILL]: wifi shut off power.
[    3.379410] [WLAN_RFKILL]: rockchip_wifi_ref_voltage: 0
[    3.379424] [WLAN_RFKILL]: rockchip_wifi_ref_voltage: wifi io reference voltage control is disabled.
[    3.379518] dhd_module_init: Exit err=0
[    3.385212] systemd[1]: systemd 219 running in system mode. (+PAM +AUDIT +SELINUX +IMA +APPARMOR +SMACK +SYSVINIT +UTMP +LIBCRYPTSETUP +GCRYPT -GNUTLS +ACL +XZ -LZ4 -SECCOMP +BLKID -ELFUTILS +KMOD -IDN)
[    3.385593] systemd[1]: Detected architecture arm.
[    3.390667] systemd[1]: Set hostname to <firefly>.
[    3.467960] Cam_Powerdowm
[    3.536872] ret: 0
[    3.566392] soc-camera-pdrv gc0329_front_5: Probing gc0329_front_5
[    3.635250] ret: 0
[    3.639883] systemd[1]: [/lib/systemd/system/fbset.service:7] Unknown lvalue 'type' in section 'Service'
[    3.642862] systemd[1]: [/lib/systemd/system/wifi-on.service:7] Unknown lvalue 'type' in section 'Service'
[    3.661411] systemd[1]: Started Forward Password Requests to Wall Directory Watch.
[    3.661503] systemd[1]: Starting Forward Password Requests to Wall Directory Watch.
[    3.665982] systemd[1]: Created slice Root Slice.
[    3.666078] systemd[1]: Starting Root Slice.
[    3.672612] systemd[1]: Listening on /dev/initctl Compatibility Named Pipe.
[    3.672695] systemd[1]: Starting /dev/initctl Compatibility Named Pipe.
[    3.677656] systemd[1]: Listening on Journal Audit Socket.
[    3.677741] systemd[1]: Starting Journal Audit Socket.
[    3.683275] systemd[1]: Listening on Journal Socket (/dev/log).
[    3.683360] systemd[1]: Starting Journal Socket (/dev/log).
[    3.688653] systemd[1]: Listening on Delayed Shutdown Socket.
[    3.688738] systemd[1]: Starting Delayed Shutdown Socket.
[    3.693250] systemd[1]: Listening on Journal Socket.
[    3.693354] systemd[1]: Starting Journal Socket.
[    3.698290] systemd[1]: Listening on udev Control Socket.
[    3.698375] systemd[1]: Starting udev Control Socket.
[    3.703813] systemd[1]: Reached target Remote File Systems (Pre).
[    3.703891] systemd[1]: Starting Remote File Systems (Pre).
[    3.709286] systemd[1]: Created slice User and Session Slice.
[    3.709370] systemd[1]: Starting User and Session Slice.
[    3.714200] systemd[1]: Reached target Encrypted Volumes.
[    3.714278] systemd[1]: Starting Encrypted Volumes.
[    3.719090] systemd[1]: Listening on udev Kernel Socket.
[    3.719168] systemd[1]: Starting udev Kernel Socket.
[    3.723607] systemd[1]: Created slice System Slice.
[    3.723711] systemd[1]: Starting System Slice.
[    3.728732] systemd[1]: Starting Load Kernel Modules...
[    3.736556] systemd[1]: Reached target Slices.
[    3.736672] systemd[1]: Starting Slices.
[    3.739356] systemd[1]: Starting Setup Virtual Console...
[    3.743600] systemd[1]: Started Create list of required static device nodes for the current kernel.
[    3.746853] systemd[1]: Starting Create Static Device Nodes in /dev...
[    3.752243] systemd[1]: Mounted POSIX Message Queue File System.
[    3.755477] systemd[1]: Starting Journal Service...
[    3.761829] systemd[1]: Starting udev Coldplug all Devices...
[    3.772361] systemd[1]: Created slice system-serial\x2dgetty.slice.
[    3.772491] systemd[1]: Starting system-serial\x2dgetty.slice.
[    3.775469] systemd[1]: Mounting Debug File System...
[    3.779741] systemd[1]: Mounted Huge Pages File System.
[    3.780021] systemd[1]: Set up automount Arbitrary Executable File Formats File System Automount Point.
[    3.781848] systemd[1]: Started Set Up Additional Binary Formats.
[    3.782854] Cam_Powerdowm
[    3.785283] systemd[1]: Starting Remount Root and Kernel File Systems...
[    3.794803] systemd[1]: Reached target Swap.
[    3.794940] systemd[1]: Starting Swap.
[    3.796004] min_w = 640,min_h = 480 ,max_real_w = 640,max_real_h = 480,max_w = 640,max_h =480
[    3.801355] systemd[1]: Created slice system-getty.slice.
[    3.801463] systemd[1]: Starting system-getty.slice.
[    3.803861] systemd[1]: systemd-modules-load.service: main process exited, code=exited, status=1/FAILURE
[    3.813420] gc0329_front_5(rk_cam_sensor:169): write reg(0xfc, val:0x16) failed, try to write again!
[    3.814428] gc0329_front_5(rk_cam_sensor:169): write reg(0xfc, val:0x16) failed, try to write again!
[    3.815544] gc0329_front_5(rk_cam_sensor:169): write reg(0xfc, val:0x16) failed, try to write again!
[    3.816389] systemd[1]: Failed to start Load Kernel Modules.
[    3.816479] systemd[1]: Unit systemd-modules-load.service entered failed state.
[    3.817171] systemd[1]: systemd-modules-load.service failed.
[    3.820610] systemd[1]: Started Setup Virtual Console.
[    3.827801] systemd[1]: Started Remount Root and Kernel File Systems.
[    3.843380] gc0329_front_5(rk_cam_sensor:335): read reg(0x0 val:0x0) failed, try to read again!
[    3.843426] gc0329(917): gc0329 read chip id high byte failed
[    3.843426]
[    3.843449] gc0329(924): error: gc0329 mismatched   pid = 0x0
[    3.843449]
[    3.843476] gc0329_front_5(rk_cam_sensor:718): error: mismatched   pid = 0x0
[    3.843476]
[    3.850156] systemd[1]: Mounted Debug File System.
[    3.863605] systemd[1]: Started Create Static Device Nodes in /dev.
[    3.943052] systemd[1]: Starting udev Kernel Device Manager...
[    3.949213] systemd[1]: Started Rebuild Hardware Database.
[    3.949471] systemd[1]: Started Various fixups to make systemd work better on Debian.
[    3.950150] Cam_Powerdowm
[    3.957274] systemd[1]: Reached target Local File Systems (Pre).
[    3.957398] systemd[1]: Starting Local File Systems (Pre).
[    3.962640] systemd[1]: Reached target Local File Systems.
[    3.962782] systemd[1]: Starting Local File Systems.
[    3.965706] systemd[1]: Starting Tell Plymouth To Write Out Runtime Data...
[    3.973992] systemd[1]: Starting Set console keymap...
[    3.985811] systemd[1]: Reached target Remote File Systems.
[    3.985932] systemd[1]: Starting Remote File Systems.
[    3.986086] systemd[1]: Started Commit a transient machine-id on disk.
[    3.989050] systemd[1]: Starting Load/Save Random Seed...
[    3.996107] systemd[1]: Mounting Configuration File System...
[    4.006636] systemd[1]: Mounting FUSE Control File System...
[    4.011433] systemd[1]: Starting Apply Kernel Variables...
[    4.025311] systemd[1]: Started udev Coldplug all Devices.
[    4.028894] ret: 0
[    4.035594] systemd[1]: Started Tell Plymouth To Write Out Runtime Data.
[    4.036644] systemd[1]: console-setup.service: main process exited, code=exited, status=203/EXEC
[    4.058662] soc-camera-pdrv gc2035_back_6: Probing gc2035_back_6
[    4.061062] systemd[1]: Failed to start Set console keymap.
[    4.061144] systemd[1]: Unit console-setup.service entered failed state.
[    4.061289] systemd[1]: console-setup.service failed.
[    4.067902] systemd[1]: Started Load/Save Random Seed.
[    4.294598] rk_cam_io(1128):SENSOR_PWRSEQ_PWRDN failed
[    4.294691] soc-camera-pdrv gc2035_back_6: Cannot get I2C adapter #2. No driver?
[    4.402829] rk_cam_io(1128):SENSOR_PWRSEQ_PWRDN failed
[    4.402848] rk_cam_io(1117):SENSOR_PWRSEQ_HWRST failed
[    4.776783] soc-camera-pdrv gc0308_front_7: Cannot get I2C adapter #2. No driver?
[  *** ] A start job is running for LSB: Rai...nterfaces. (1min 24s / no limit)
回复

使用道具 举报

152

积分

0

威望

6

贡献

技术小白

积分
152
发表于 2016-11-2 17:53:13        只看该作者  沙发
没看清最后一行是什么。接显示器有图形界面吗?之前有做过什么操作?
回复

使用道具 举报

36

积分

0

威望

0

贡献

游客

积分
36
发表于 2016-11-2 18:02:59        只看该作者  板凳
busybee 发表于 2016-11-2 17:53
没看清最后一行是什么。接显示器有图形界面吗?之前有做过什么操作?

直接重装了系统,和网口的配置有关系,上网了就没有最后一行了。
回复

使用道具 举报

您需要登录后才可以回帖 登录 | 立即注册

本版积分规则

友情链接 : 爱板网 电子发烧友论坛 云汉电子社区 粤ICP备14022046号-2
快速回复 返回顶部 返回列表