|
|
板子反复一直启动不了 一直在Starting kernel 反复这样 有人帮看下不
发表于 2015-8-10 22:33:47
浏览：16606
|
回复：14
打印
[复制链接]
楼主
Starting kernel ...
DDR Version 1.00 20141007
In
SRX
Channel a: DDR3 200MHz
Bus Width=32 Col=10 Bank=8 Row=15 CS=1 Die Bus-Width=16 Size=1024MB
Channel b: DDR3 200MHz
Bus Width=16 Col=10 Bank=8 Row=15 CS=1 Die Bus-Width=16 Size=512MB
OUT
U-Boot 2014.10-RK3288-06-gb1ceed8-dirty (Mar 26 2015 - 10:37:10)
CPU: rk3288
CPU's clock information:
arm pll = 600000000HZ
periph pll = 297000000HZ
ddr pll = 200000000HZ
codec pll = 384000000HZ
Board: Rockchip platform Board
DRAM: Found dram banks:2
Adding bank:0000000000000000(0000000040000000)
Adding bank:0000000040000000(0000000020000000)
128 MiB
storage init OK!
Using default environment
GetParam
check parameter success
Unknow param: MACHINE_MODEL:rk3288!
Unknow param: MACHINE_ID:007!
Unknow param: MANUFACTURER:RK3288!
Unknow param: PWR_HLD: 0,0,A,0,1!
failed to prepare fdt from boot!
power key: bank-0 pin-5
pmic:act8846
SecureBootEn = 0, SecureBootLock = 0
#Boot ver: 2015-03-26#2.19
empty serial no.
checkKey
vbus = 1
no fuel gauge found
no fuel gauge found
read logo_on switch from dts [0]
no fuel gauge found
got recovery cmd from misc.
failed to load fdt from recovery!
ERROR: [get_entry_ram]: Cannot find logo_kernel.bmp!
Secure Boot state: 0
kernel @ 0x02000000 (0x00653618)
ramdisk @ 0x05bf0000 (0x003d3053)
bootrk: do_bootm_linux...
Loading Device Tree to 0570c000, end 0572a935 ... OK
Add bank:0000000000000000, 0000000040000000
Add bank:0000000040000000, 0000000020000000
Starting kernel ...
就一直这样Starting kernel
|
|
